Ring sizes available?

[G Cham 05 silver redline]

Originally Posted by djt81185

Do you have any of those Billet idlers done? Also can a stock car run the 2.7 if they use a boost controller to limit the boost. Also how do we order. I've been trying to all weekend lol.

Dan

GIVE DOUG A CALL FOR YOUR ORDERS 313.388.8228

[djt81185]

Originally Posted by G Cham 05 silver redline

GIVE DOUG A CALL FOR YOUR ORDERS 313.388.8228

Taken care of yesterday...got a 2.7 and a 2.9 coming

Dan

[G Cham 05 silver redline]

Originally Posted by djt81185

Taken care of yesterday...got a 2.7 and a 2.9 coming

Dan

GOOD TO HEAR WHO'S DOING THE INSTALL

[djt81185]

Me and my new pulley puller tool (If I was in MI I would have stopped by already). Today should be happiness day Laptop, scan tool, and maybe hopefully the UPS man will bust his ass and get the pulleys here today. Hope the boost controller comes as well.

Dan

[Redlinekid_04]

How much did it come out to??

[mgm1979]

Had a nice brown box waiting for me when I got home yesterday...all three pulley rings and an idler pulley (the other idler pulley's on B/O). Can't wait to throw them on the car tomorrow and get the dyno #s with them AND stage 1!

[djt81185]

G Cham, Doug maybe you can chime in.

I was wondering if you would be able to make a 2.6" to fit our snout without machining. Is it possible or would the material become too thin?

Thanks,

Dan

[mgm1979]

Screw it - with that ZZP snout machining tool out, when can we expect BF to start producing smaller pulleys!?!?

[G Cham 05 silver redline]

Originally Posted by djt81185

G Cham, Doug maybe you can chime in.

I was wondering if you would be able to make a 2.6" to fit our snout without machining. Is it possible or would the material become too thin?

Thanks,

Dan

THE 2.7 IS THE SMALLEST RING YOU CAN GO WITH, WITHOUT HAVING TO MACHINE THE SNOUT DOWN

[djt81185]

Doug

Do you think you will be able to make 2.5 and 2.6 inch pulleys for your hub. I want to go smaller but you don't have anything smaller. If so how long would that take? How far would I have to have the snout machined...should I get it machined with the zzp tool then come down for measurements? 2.5 is I think the limit.

Thanks,

Dan