WTB: ZZP/Intense 2.8/2.9/3.0 Pulley

[handyjoe]

Hey guys, lookin to buy a bigger pulley for the road race I'll be doin in a couple weeks. I get the feeling I'll be majorly heat soaked before the end of the first run with my 2.6, so I'm thinking a bigger pulley might be in order. If anyone can help me out, PM me, I'd appreciate it.

[NoRemorse]

Originally Posted by handyjoe

Hey guys, lookin to buy a bigger pulley for the road race I'll be doin in a couple weeks. I get the feeling I'll be majorly heat soaked before the end of the first run with my 2.6, so I'm thinking a bigger pulley might be in order. If anyone can help me out, PM me, I'd appreciate it.

Honestly, as it being our first time, heat soak will be NOTHING to worry about, compared to driving

If you want, we can make it bleed boost. I know it will still spin jsut as fast, but it will have MUCH less strain on it.

Hell, did you know that bypass during cruising removes about 80% of the parasitic loss?

[handyjoe]

Originally Posted by NoRemorse

Honestly, as it being our first time, heat soak will be NOTHING to worry about, compared to driving

If you want, we can make it bleed boost. I know it will still spin jsut as fast, but it will have MUCH less strain on it.

Hell, did you know that bypass during cruising removes about 80% of the parasitic loss?

Its still gonna cause heat while its spinning. Plus, I was thinkin that as long as it only takes a few minutes to change the pulley, I could swap it out for a road trip, put less wear & tear on the motor for a few hours, then swap the smaller pulley back on for some around-town fun.

And I know my driving is gonna suck, you've seen my timeslips.