New STOCK PULLEY RECORD and PB!!!!!!!!!!

[ralliartist]

Went to the 1/8th mile. Set a new record on stock pulley and a new Personal Best. Ran a 8.7@80mph! 2.009 60ft. I launched at 5200rpms on that launch. The track was biting hard! I don't know what else I can do with the car as it sits to cut that 60ft any lower. I need drag bags for sure to get any better out of the hole. Vids coming soon.

all runs in sequence were:

9.0@79.6mph /2.1 60ft. (3K rpms launches, 21psi in the tires)
8.92@80mph /2.08 60ft.
8.81@79.92mph /2.02 60ft.
8.91@79.9mph /2.07 60ft.
8.981@79.12mph /2.212 60ft. (first launch at 5200rpms, 21psi in the slicks, too much air)
8.76@80.2mph /2.009 60ft. (new record! launched at 5200rpms, 18psi in the tires)
8.89@80.15 /2.08 60ft. (clutch said I'm done with launching at 5200rpms)

Previous best was 8.8@80mph with 2.0 60ft. in the 1/8th at KCIR which is lower altitude.

9.0 run, 3K rpm launch


8.9 run against 60trim ser spec v



8.8 run


8.9 run


another 8.9 run


the new record setting 8.7 run (freeze frame the launch and check out the squat!)


8.8 run, 6200rpm launch, clutch was done for the day.

[ralliartist]

bump for those that don't get on ss.net

[bigd2010]

damn nice times

[ralliartist]

thanks man!

[FunkyStickman]

I had the same thing happen to mine, the clutch just couldn't handle the abuse. And I didn't even have slicks! Good job, most excellent.

[thedubsack85]

nice launch on the new PB.. but when i had traction bar's on my RL the weight didnt shift.. and if they were tight no hop and no weight transfer.. made for nice times on a stage 2 RL.. but still not faster then your car.. cooling mod's FTW..

[ralliartist]

I'm ordering a msd launch control (2-step) and drag bags as soon as I return from my deployment, which will be end of september. I'm also gonna throw an intake/3.5" throttle body/header/downpipe to the mix.

12's or bust when I get back, on stock pulley.

[04Whiner]

Nice looks good keep it up

[Blu_Redline]

Whathave you done to avoid wheel hop at the high launches??? I have solid urethane mounts and BWoody's traction bars and still get hop at the strip if I try to launch over 3000 rpm.

[qwikredline11]

awesome Ralliartist! when you get back from deployment i will have a rotated mount set for you with a better axle for one side (wheel hop killer) ...good luck stay safe