Alright....well I made just a little bit of progress today on my sub install while using the factory radio with my non-AAS system in my '07

First off.....flip down the rear seats and pull the plastic push pins out that hold the back shelf down. A...... Read More

So the stock speakers suck. My subs added some nice lows, but then I wasn't hearing the highs.....so I decided to add some tweeters.

First thing I did was buy the Advanced Audio System sail panels (~$20-25 for the pair) that have tweeters in them...... Read More

Ok so I see a lot that there are still those people who do not know how to put pictures into their reply in a thread or post pictures whatsoever! So follow the steps below and you will master how to do this!

First, we will discuss how to put...... Read More

For those that like to gut their cars on track day, or just for fun... *coughTibscough*:

Tools:
1 x 15mm wrench or socket wrench

How to remove the driver's side...
First:
Unclip the Driver's side "Seatbelt...... Read More

Ok here is how I did mine, This is a easy Mod!
1st)Pop Cap On Shifter Knob & Remove Screw if you have 1!
2nd) PULL LIKE HELL!
3rd) Pull straight back on dash end of boot, so it unlaches!
4th)Slide Whole Boot & Reverse Lock out off Shifter...... Read More

edit: things have been moved around, new location of pictures is at http://www.uslsja.com/howto/sunroofdrain/ and im too lazy to change the urls

enjoy

This is for all the people that have gotten in they're car after a hard rain, only...... Read More

This article will give you information on how to fully participate here. From registering, posting images, uploading to your gallery, to searching the forums properly.... Read More

secondstringsoldier

---

This How-To takes you through step-by-step to install and aftermarket tachometer and tach adapter.... Read More

Having trouble with pics in this "How To" forum
try here
http://www.redlineforums.com/forums/219564-post1.html... Read More

How to install lowering springs

Tools Needed:
- 19mm socket
- 18mm socket
- 21mm socket
- E-8 socket
- Ratchet or Breaker Bar
- Hammer
- Jack... Read More

How to install lowering springs


Tools Needed:
- 19mm socket
- 18mm socket
- Ratchet or Breaker Bar
- Jack
- Jack Stands
- Torque Wrench... Read More

Alternative to solid mounts

---

This is an outline of how to fill your motor mounts using urethane (3M windo-weld) or other solid-drying substance. This was done on a 2004 Ion Quad Coupe but should be applicable to redlines as well.... Read More