Alright....well I made just a little bit of progress today on my sub install while using the factory radio with my non-AAS system in my '07

First off.....flip down the rear seats and pull the plastic push pins out that hold the back shelf down. A...... Read More

So the stock speakers suck. My subs added some nice lows, but then I wasn't hearing the highs.....so I decided to add some tweeters.

First thing I did was buy the Advanced Audio System sail panels (~$20-25 for the pair) that have tweeters in them...... Read More

for short ram install using the stock top lid? if you want to remove the bottom box itll take about 1 hr or so.

1) remove the 90 degree twisted stock elbow that connects to the TB.(8mmm socket)

2) unbolt the ground wire that is located next and...... Read More

I've loved the feel of the B&M since I first installed it, but the shaft length is a little to long fo me, so I decided to fix that. This mod will allow you to keep the reverse lockout feature and use the knob that came with the shifter (or use any...... Read More

Well here it is for all those of you waiting for it. How I turned my side emblems into turn signals. Now I need to make one thing clear right now, there are many things in this how-to that you can do different, this is just what worked best for me...... Read More

How to install an LC1 wideband into an LSJ-equipped car (Redline, Cobalt SS)... Read More

Spring Install: Zfactor's End All for Spring Installs

---

Spring Install: Zfactor's End All for Spring Installs... Read More

Installing a coppertop subframe brace

---

Tools needed

19mm ratchet/tire iron
Metric tool set
Jack
Jack stands
BFH - you always can use a bigger effing hammer... Read More

I will add pics later, I need to get my camera and upload.... Read More

A quick write-up on how to bleed the clutch that gives some people problems.... Read More

Get rid of idle surge

---

For all of those people out there experiencing surging problems at an idle, this is a fix that only takes about 30 minutes max.... Read More

http://video.google.com/videouploadf...64__cmVhcg.wmv



tools needed:
16 mm wrench
17 mm ratchet


sway bar:... Read More