1.Disconnect the blower motor electrical connector.
2.Remove the lower blower motor cover retaining screws.
3.Remove the lower blower motor cover.
4.Remove the blower motor nuts.
Important: Cut through the case as straight as possible because the motor cup must be replaced. In order to prevent damage to the component, do not cut any deeper than necessary to remove the motor cup.
5.Remove the blower motor and cup from the lower case by cutting through the case between the circular ribs around the motor with a sharp utility knife.
6.Release the blower motor retaining tab and remove the motor from the cup.
1.Install the blower motor (1) into the motor cup (2) that was cut out of the lower case.
Notice: Refer to Fastener Notice in Service Precautions.
2.Install the blower motor nuts (3). Tighten the nuts to 2.4 N.m (21 lb in).
3.Attach the service ring (4) to the motor cup (2) with the screws (5) included in the kit. Tighten the screws to 1.8 Nm (15 lb in).
4.Install the blower motor and service ring into the HVAC module using the screws (5) included in the kit. Make certain the blower motor electrical connector is pointing rearward in the vehicle. Tighten the screws to 1.8 Nm (15 lb in).
5.Install the lower blower motor cover.
6.Install the lower blower motor cover retaining screws. Tighten the screws to 1.8 Nm (15 lb in).
7.Connect the blower motor electrical connector.
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.