Raptor shift light install... help...

[CuriousGeorge]

okay, we have power, we have it set for 2 cyl mode, but i can not for the life of me get it to read a signal. where the hell is the tach signal wire? i poked and proded through the ecm harnesses and couldnt find one.

pics would be much appreciated!

[Badanthony]

the tach signal can be picked up off the green and white wire in one of the harnesses with green tape on it. You need to set the raptor to 1 cylinder mode. I know this works cause mine has been working for at least 3 months now. good luck.

[mrphoto103]

Did you get a knob on other than stock? How did you get around the reverse lock out?

[CuriousGeorge]

what green tape? i had teh dash completely stripped, the wiring harnesses torn down, (mental note, need elec tape) and i could not find a damnable green and white wire!, someone hook me up with a picture. and mr photo, wtf are you talking about....

[mrphoto103]

That's why I shouldn't read posts on my way out the door and reply. I thought you said shift knob....not shift light

Sorry about that.

[Badanthony]

In the engine compartment. Look in the engine compartment.

[CuriousGeorge]

okay, if its in the engine compartment, how do i go about getting through the firewall?

[XeroState]

Use the the hole in the firewall behind the brake pedal (I think that is the one most ppl use for almost everything), its just a black gromet (spelling?) with wires running through it. You may have to pull down the carpet a bit though.

[CuriousGeorge]

i found a hole in there yesterday, but it felt like it was blocked off or something? i tried to stick my finger through it, and a clothes hanger, but it would only go about 1", then stoppage. is it the one thats got like a foam blocker or something?

[XeroState]

No idea. I've never done it, but I found the gromet one day cleaning my car.