2.9 Pulley Install w/pics

[Sp00ner]

Originally Posted by LSJ PUP

I have a question for anybody that knows their stuff. When we installed the 76mm idler pulley, the 2.9 and the idler were not in sync. The idler was off to the right instead of being dead center with the SC pulley. We decided to use the stock idler for now. Can I just use a washer or two to line them up or is there a more proper way to do this?

Did you have the idler backwards?

[AlphaJaguar5]

Originally Posted by Sp00ner

Did you have the idler backwards?

Come on... lol. Do I look that retarded?

Nevermind. Dont answer that, lol

[LSJ PUP]

Originally Posted by AlphaJaguar5

Come on... lol. Do I look that retarded?

Nevermind. Dont answer that, lol

In other words No. We tried it the other way and it won't go on because of the lip of the pulley. We know it is on right, but it just doesn't line up. I don't get it.

[ION/GONE]

Originally Posted by AlphaJaguar5

Come on... lol. Do I look that retarded?

Nevermind. Dont answer that, lol

Alpha, you gotta quit setting yourself up for these guys.

[Doc_ss]

IIRC the lip goes on the inside, towards the motor.

[Track Slut]

its just the way it is, mine sits off just to the side too. where the supercharger sits in the ss im suprised you can even get a puller in there. looks good!

[LSJ PUP]

Originally Posted by Doc_ss

IIRC the lip goes on the inside, towards the motor.

Ummm...I don't think so. I've been told by everyone that the lip is on the outside. We couldn't even get it on with the lip on the inside.

[LSJ PUP]

Originally Posted by Track Slut

its just the way it is, mine sits off just to the side too. where the supercharger sits in the ss im suprised you can even get a puller in there. looks good!

How far is your offset? Do you have any pics of the pulley from above?

[Track Slut]

i could go get some pix for you gimme a few minutes

[Track Slut]

i cant get a clear picture to show it but its off by 1 groove on my car