2.9 Pulley Install w/pics

[LSJ PUP]

Originally Posted by Track Slut

i cant get a clear picture to show it but its off by 1 groove on my car

Mine is a little closer than that right now, but with the 76mm, its a couple off I believe. I didn't think that it looked safe enough to drive with so I left it off until I need it when I install the 2.7

[Doc_ss]

Originally Posted by LSJ PUP

Ummm...I don't think so. I've been told by everyone that the lip is on the outside. We couldn't even get it on with the lip on the inside.

your correct, the inside doesn't have the lip, just went and looked. duh
somethings wrong....the hub being backwards or not on far enough....they should line up.

[LSJ PUP]

Originally Posted by Doc_ss

your correct, the inside doesn't have the lip, just went and looked. duh
somethings wrong....the hub being backwards or not on far enough....they should line up.

I thought we either put the hub on too far or not enough, but that doesn't seem like the case. The hub is flush with the snout rod. I don't know if the tensioner could be bad. It looks fine.

[Doc_ss]

If you remove the pulley now, which way is the beveled edge of the hub, towards you or the snout of the supercharger?

[AlphaJaguar5]

Towards the snout of the supercharger. We used my car for reference and something with the bearing in the idler has to be screwed up cuz I did his car just like I did mine.

[Mase]

Originally Posted by Track Slut

i cant get a clear picture to show it but its off by 1 groove on my car

same with mine, 1 groove.

How come you guys took off the snout??

[Doc_ss]

Originally Posted by AlphaJaguar5

Towards the snout of the supercharger. We used my car for reference and something with the bearing in the idler has to be screwed up cuz I did his car just like I did mine.

I'll go take my pulley off later but I believe the bevel (is that spelled right..?? lol who cares) is away from the supercharger.

[sheek360]

gratz pup, any slip? hows she pulling now?