e brake stickin

[roderick]

I just bleed my brakes and clutch and after that i tested it on the road but i noticed i couldnt put cruse on and the brake light was still on. I got back home and checked all my lines and sensors and everything looks fine i even checked the ebrake to see if it was down all the way and it was. What could be wrong or what could i do to fix this?

[redlineinsc]

was the car lagging when the ebrake light was on?

this clutch is near impossible to bleed

[redlineinsc]

the sensor that detects the ebrake on is shitty in these cars

[qwikredline11]

Originally Posted by roderick

I just bleed my brakes and clutch and after that i tested it on the road but i noticed i couldnt put cruse on and the brake light was still on. I got back home and checked all my lines and sensors and everything looks fine i even checked the ebrake to see if it was down all the way and it was. What could be wrong or what could i do to fix this?

did you putnew rear brake padsin? You gotta use the service tool to wind the caliper piston back in if youdont yuou can get issues like u are talking about. if not check the cables are not binding...cheers

[roderick]

The car lagged a little but not much and i bleed the brakes because i installed a new master brake cylinder the other day.
it does not drag on the back but the light is always on.

[roderick]

Originally Posted by redlineinsc

the sensor that detects the ebrake on is shitty in these cars

were would this sensor be? and how much does it cost to get a new one?

[lilhomieb07]

Check the fluid level in the master cylinder that makes the light come on if its low, check the wires on the brake itself when u take the boot off and make sure the wire/senor to the master is in all the way and not sitting there barely touching.

[roderick]

i check the fluid it looked full but i added some anyways and it over flowed into the other side and it used 10 out of the 12 oz brake fluid now the light is gone thanks.

[lilhomieb07]

Hahahha good one bro, lol ya ull bleed alot of fluid after u bleed the brake and drive without checkin it, but ya i had to add some when my light randomly came on. Haha make sure to check the fluid often to see if u lose some, make sure you did the bleed right!!!!

[redline87]

huh mine was hard as hell to pull for awhile and had to be on the final click to engage now its normal...but i had a hard time breaking the drifting habbit from my 3 previous rwd vehicles so all y ebrake drifts and dumb shit like that most likely caused it lol but my light does come on now and then w/o the brake being up