sorry im really out of it today

[pclear9061]

does anyone have any pics of the install for the rear sway bar ????? i need help ...... i cant seem to get these damn things on also i couldnt get the strut tower bar on ...... what did yall do to get it on .... mines short by about 1/8-1/4 of an inch ..... help please ......

[IERedLine]

For the front strut bar use something and tap the pins a bit till one side goes on, then goto the other side and tap that pin untill it falls into place. Dont hit it too hard.. just tap it.. You will see it moving...

Scott

[pclear9061]

HAHAHAHA thanks .... i finally got it just a min ago .... i drilled the holes just a tad bigger then it was soooooo close to going and i got really pissed and put one side of the bar on so the STB was at the top of the bolt then pulled the STB the other direction and it was very very close so i took the hammer and fucking smashed the STB on .... no damage and its on perfectly .... nice and tight ..... i got a really short temper right now ...... now its off to the part store to get bolts for the RSB

[mrphoto103]

Make sure you bolt the RSB on with the correct kind of nut. Talk to Rice Eater/Cynic on the exact one to use. It'll keep it from falling off.

Though the car is dirty you can see both bars in my gallery.

[pclear9061]

heres some pics of the strut tower brace














and the rear sway bar















a couple of the engine and pulley and the dual TQB

[Sp00ner]

Did you use 'stop' nuts on the rear bar PC? Pay attention for the first couple days and make sure you don't have a nut fall off... hehe... a nut fall off...

[pclear9061]

hahahaha yes i used lock nuts with that lock tight type stuff inside the nut