I wanted to take a look at my intake to make sure it was tight and doing ok. I decided I will take off the drivers side wheel to get better access. I loosen the wheel up while on the ground and then proceed to jack up the car. Well I jack it up, take the tire off . Then I keep jacking it up. I reach the limit and the car slips off the jack . Car falls on the rotor the jack is stuck under the car. the cobra heat exchanger has bent around the jack. I manage to get the factory jack to squeeze under the car to lift up the drivers side with out a tire on it.
I notice the cobra heat exchanger has a large U shaped dent along the bottom of it.
But the brackets still held it in place. It is still strong as ever with the brackets holding it in place. That is a quality bracket.

I've got some front end parts still if you need anything.