hp tuners boost question

[burlap1980]

i am loging my runs on hp tuners but it does not read my boost kinda want to log it also any help would be great.

Also is there anyway to read a/f ratio thru the narrow band on hp tuners? wanna know if i am runnig rich lean or whatnot. newb to hp tuners so any help is greatly apreaciated(sp)
(looking for a wide band now)

[Cynic]

Originally Posted by burlap1980

i am loging my runs on hp tuners but it does not read my boost kinda want to log it also any help would be great.

Also is there anyway to read a/f ratio thru the narrow band on hp tuners? wanna know if i am runnig rich lean or whatnot. newb to hp tuners so any help is greatly apreaciated(sp)
(looking for a wide band now)

I haven't used logging much (too busy with other shit) but I know you can't get anything from the narrow band. Boost....I haven't looked to see but it should be on there as an interceptor guage can read it. I would imagine a laptop should be able to as well.

[Firestorm]

im not near my car for a few more days, but i believe if you insert a custom PID, from engine/airflow/manifold vacuum (psi), which gets its reading from the ecm.
someone wanna double check this and maybe post a hpt config file.

[ArrivalBlueSS]

You want to log the MAP to get boost, remember your Boost is the MAP - 14.7.

For narrow band readings you can use the bank 1 sensor 1 heater O2.

[Doc_ss]

specifically, [SENS.30.IMP]-14.7

[jmc007]

Where can we see, add or modify those PID (formulas) ?

[Doc_ss]

open the Scanner then open the Table Display
Right-click inside the Table Display and you'll see a drop-down menu where you can add PID(s) or make a User Defined PID