Saturn ION RedLine Forums banner

pulley

  1. Stage Kit Questions

    Performance Modifications
    I have done a bit of research but still have quite a few unanswered question or questions that haven't been fully confirmed. I have completely stock Redline, that i have recently obtained and was looking into the stage kits, not sure which to get and what pulley/injectors etc was hoping you guys...
  2. WTB - Stage 2 parts

    Buy/Sell Parts
    Alrighty, just waiting on my income tax return and I'll be set to start buying parts. The parts I'm looking for lists as follows: 1. 3.1 (black) SC Pulley 2. Oversized Tensioner Pulley 3. 42 or 50# Injectors 4. Modular Pulley 5. ZZP injector harness - EV1 6. AERO FORCE - PT Gauge. Red Face. 7...
  3. Help with Stage 2 Upgrade

    Performance Modifications
    This is going to probably be some basic stuff for you guys and most likely discussed a million times but im looking for some straight answers on upgrading my stock RL to a stage 2. -My question is if i upgrade the injectors, pulley, and belt, is the only thing left ill need is a good tune...
  4. boost problem please help!!!

    General Discussion
    ok, so its been about a month now and i have a 2.9 pulley, stage 2 belt, 42lb injectors, stage 3 pcm, heat exchanger, magnaflow exhaust and cai. and i am boosting around 13psi on the street just on a side street, and im doing about 15psi on the highway in higher rpms. i know 2.9 pulley should do...
  5. 3.1 and belt issue

    General Discussion
    Hey just wondering, im brand new to this forum. Just got my 3.1 pulley and new belt, finally got the old pulley off the supercharger, got the new hub on. Ordered all my stuff from zzp...Question is, the belt they gave me looks to small.....Belt is 20mmx1665mm OC...Its the K060650...Does anyone...
  6. FS 2.7" ZZP Pulley (5 Bolt)

    Buy/Sell Parts
    Used ZZP 2.7" 5 bolt pulley. Will fit ZZP and Intense hubs. $40 shipped in the US. I made 285whp 265wtq with it.
  7. IDCs with 60# injectors and 2.8"

    Tuning & Electronics
    I wanted to find out what other people are seeing for an Injector Duty Cycle with 60# injectors and a 2.8" pulley. Here is mine. I am at 73% on this run which is second gear. In third gear the IDCs will get up to 75%. What is everyone else at?
Top