[2007 ion redline silver]

I opend the bleed valve on the transmisson where the line runs into it to hook it up with a vacume pump. And there was a leak in the setup so I couldn't get it to pressurize. Then I tried the vacume pump on top of the resivour pumped it 100 times still nothing clutch goes to the floor. There orgnialy was a leak from a line going from resivour to the slave. I redid the line and I belave it is not leaking but once again u can't grt the transmission to bleed so I have no clutch any help would be awesome and I don't think there is a leak anymore

 

[2007 ion redline silver]

I opend the bleed valve on the transmisson where the line runs into it to hook it up with a vacume pump. And there was a leak in the setup so I couldn't get it to pressurize. Then I tried the vacume pump on top of the resivour pumped it 100 times still nothing clutch goes to the floor. There orgnialy was a leak from a line going from resivour to the slave. I redid the line and I belave it is not leaking but once again u can't grt the transmission to bleed so I have no clutch any help would be awesome and I don't think there is a leak anymore

Edit I removed the bleeder valve completely put vscume to the resivor and the vacume was still holding pressure that can't be right?

 

[2007 ion redline silver]

Any help would be appreciated

 

[Eagle_f90]

The site is bot very active. People visit daily but not hourly so it kighit be a bit before someone that can help sees this. I know the clutch is hard to bleed and it has been talked about in the past so try some searchung to see if anything helps.

 

[2007 ion redline silver]

Thank you