Saturn ION RedLine Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
2,009 Posts
Discussion Starter · #1 ·
any suggestions on how to attach grill mesh to the back of the outer vents?
(i'm cutting out the fake centre parts)
there's no pegs to hold the mesh like the centre section has....

thanks
 

·
Registered
Joined
·
2,110 Posts
SatredL said:
Did you try some 2 part epoxy?
That is what I used... 30 minute 2 part epoxy... put it on with a q-tip around each of the little alumnium points... it is not going ANYWHERE...
 

·
Superd00d
Joined
·
22,040 Posts
Doin mine this weeknend as well... what did you guys use to 'prep' the areas where you cut out the fake mesh? Sand it down? What did you cut it with?
 

·
Registered
Joined
·
2,110 Posts
Sp00ner said:
Doin mine this weeknend as well... what did you guys use to 'prep' the areas where you cut out the fake mesh? Sand it down? What did you cut it with?
I just used a dremel with a routing bit at a relly high speed, it just sort of melts it way through it... the house smelled like ass.... I did not sand prep the black insert. It stuck just fine with out it at all.
 
1 - 8 of 8 Posts
Top