Wiring A Hi/Low Impedance Adaptor to OEM

4276 Views 5 Replies 4 Participants Last post by SoCo Lime, Feb 21, 2005

BKTU1

Discussion Starter · Feb 20, 2005

I was wondering if any one has there OEM radio hooked up to an amp. If so you proably used an Hi/Low impedance adaptor so that you could hook the amp up to RCA Jacks. If any one has done this please let me know what speaker wires i connect the adaptor to.

Save

1 - 6 of 6 Posts

goofyguy

· #2 · Feb 20, 2005

i used the high level inputs on the amp. I know for a fact that you cant just wire it into the Rca's.

Save

ALL4GLH

· #3 · Feb 20, 2005

I think i did what you are talking about. The adaptor that connects to the speaker wire and then turns it into RCA jacks? Here are a few pics, let me know if this is what you are talking about.

See less See more

Save

BKTU1

Discussion Starter · #4 · Feb 21, 2005

Alll4glh that is exactly what i am talking about. did u just connect it to the speakers on top of the trunk?

Save

ALL4GLH

· #5 · Feb 21, 2005

I tapped into both of the rear speakers. I can take some more pics if you like.

Save

SoCo Lime

· #6 · Feb 21, 2005

usinng a high level input is always skechy. check out this link. i have been a customer with this company for 3 years and they are the best in the business and have the lowest prices. this will make your installation a snap.

http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Partnumber=265-025

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Wiring A Hi/Low Impedance Adaptor to OEM

BKTU1

goofyguy

ALL4GLH

Attachments

BKTU1

ALL4GLH

SoCo Lime

Top Contributors this Month